Dynomotion

Group: DynoMotion Message: 979 From: albertplatek Date: 3/15/2011
Subject: Edit KmotionCNC tool length data using C program.
Hi Tom

I want to write tool length directly to "Edit Tool File" using C program, but when I write tool length directly in Default.tbl file, I need push edit button in KmotionCNC to refresh new data.

Is it possible to get automatic data reloading of new length of tool in KmotionCNC?

Regards
Albert
Group: DynoMotion Message: 980 From: Tom Kerekes Date: 3/15/2011
Subject: Re: Edit KmotionCNC tool length data using C program.
Albert,
 
Try replacing this DLL in V4.23
 
 
Regards
TK

Group: DynoMotion Message: 981 From: albertplatek Date: 3/16/2011
Subject: Re: Edit KmotionCNC tool length data using C program.
Tom,

Thank you for the fast response, now it is working ok.

Regards
Albert

--- In DynoMotion@yahoogroups.com, Tom Kerekes <tk@...> wrote:
>
> Albert,
>
> Try replacing this DLL in V4.23
>
> http://www.dynomotion.com/Software/AlwaysLoadToolTable/GCodeInterpreter.dll
>
> Regards
> TK
>
>
>
>
> ________________________________
> From: albertplatek <albertplatek86@...>
> To: DynoMotion@yahoogroups.com
> Sent: Tue, March 15, 2011 4:51:29 PM
> Subject: [DynoMotion] Edit KmotionCNC tool length data using C program.
>
>  
> Hi Tom
>
> I want to write tool length directly to "Edit Tool File" using C program, but
> when I write tool length directly in Default.tbl file, I need push edit button
> in KmotionCNC to refresh new data.
>
> Is it possible to get automatic data reloading of new length of tool in
> KmotionCNC?
>
> Regards
> Albert
>